Home » News » How SpaceX Caught Starship: Every Step of the First Ship Catch From Orbit

How SpaceX Caught Starship: Every Step of the First Ship Catch From Orbit

Companion video. Open on YouTube

On Saturday, November 14, 2026, a spaceship came back from almost a full day in orbit, fell through the atmosphere sideways, flipped upright and stopped in midair beside the tower it had launched from. Two steel arms closed under it and held it there.

Nobody had caught a spaceship returning from orbit before. SpaceX did it on Starship Flight 15 with Ship 42 and the tower it calls Mechazilla. Our video above walks through the whole trip in order, using SpaceX’s own footage, and this article sets out each step in writing so you can follow along or come back to a detail.

Two rockets, no landing legs

Starship is really two rockets stacked on top of each other. The bottom one, Super Heavy, is 72 meters (236 feet) tall and has 33 engines. Its job is to push everything off the ground for the first couple of minutes.

Diagram of the Starship rocket: Super Heavy booster, 72 meters (236 feet) with 33 engines, and the Starship ship, 52 meters (171 feet) with 6 engines
Super Heavy and the ship, stacked. Source: SpaceX Starship vehicle page.

The top one is the ship, also called Starship. It is 52 meters (171 feet) tall with six engines: three built for flying through air and three built for space. Stacked, the pair stands 124 meters, or 407 feet. SpaceX calls it the most powerful launch vehicle ever developed.

Neither half has landing legs. Both are meant to fly back to the launch site and be caught by a tower. That design choice shapes everything that follows.

Launch and the split

Flight 15 lifted off on Friday, November 13, from Starbase, SpaceX’s launch site in South Texas. About two minutes and twenty seconds in, the two halves separated using a method called hot staging. The ship lights its own engines while still sitting on the booster and pushes itself away.

From there they went separate ways. The ship kept climbing toward orbit. The booster turned around to head home.

Insights by TechCity, every Sunday.

Tech explained for people who use it.

The booster that did not make it back

The booster was supposed to be caught too. SpaceX had caught Super Heavy boosters three times before, in October 2024, January 2025 and March 2025.

This time it did not happen. To reverse direction, a booster fires its engines in what is called the boostback burn. Super Heavy relit 32 of its 33 engines, but the burn ended early because it was running low on fuel. SpaceX says it is still looking into why.

The booster’s own computer then decided it could not safely reach the tower and called off the catch. It steered out over the Gulf of Mexico and hovered over the water. As its engines shut down, its flight termination system was triggered. That is the safety system that destroys a rocket that cannot be brought down safely. Turning out to sea first keeps a rocket in trouble away from people and from the launch site.

Almost a day in orbit

The ship reached orbit, fired one engine to settle into its path, and released 26 Starlink internet satellites through a slot in its side. SpaceX says it made contact with every one.

Then came the wait. For more than 20 hours the ship circled Earth while the flight team watched its systems. SpaceX’s timeline lists three return checks along the way, over Hawaii, then Chile, then Hawaii again. SpaceX does not spell out what each check covers. The plain reading is that each one confirmed the ship was healthy enough to keep the plan of flying home.

Coming back through the heat

About 21 and a half hours after launch, the ship relit one engine for roughly ten seconds. That is the deorbit burn. It slows the ship just enough that its path dips into the atmosphere.

SpaceX’s on-screen data showed the ship hitting the upper atmosphere at about 26,000 kilometers an hour, roughly 16,000 miles an hour. At that speed the air in front gets squeezed so hard it glows. Most of the heat comes from that squeezing, not from rubbing.

The ship is stainless steel, and steel alone would not survive. One side is covered in thousands of black, six-sided ceramic tiles that take the heat and give it off again. The six-sided shape matters: the gaps between hexagons zigzag, so hot gas has no straight path through.

Diagram comparing square heat shield tiles, whose straight gaps let hot gas through, with hexagon tiles, whose zigzag gaps leave no straight path
Square tiles leave straight gaps; hexagons leave zigzags. Simplified diagram.

Tiles have been one of Starship’s hardest problems. On earlier test flights some cracked or fell off. A ship you plan to catch and fly again cannot come home scorched.

The belly flop

The ship falls back through the air flat, belly first. Space fans call it the belly flop. Falling flat turns the whole ship into an air brake and keeps the tiled side facing the heat.

To steer, it moves four flaps, two near the nose and two near the tail, much like a skydiver uses arms and legs. SpaceX says the ship flew toward the Texas coast and swung out over the Gulf in one last wide turn, lining up with the tower it had left 22 and a half hours earlier. About 20 minutes after entering the atmosphere, it dropped below the speed of sound.

The last 18 seconds

The catch itself took about 18 seconds from the moment the engines lit. These times come from SpaceX’s published timeline, which SpaceX marks as approximate.

Seconds after engines lightWhat happens
0Three engines light while the ship is still falling flat
About 2The ship swings upright (the landing flip)
About 10It drops to two engines
About 17It drops to one engine
About 18The last engine shuts off and the arms take the weight

How the arms hold a spaceship

The tower’s two arms are nicknamed chopsticks, but they do not squeeze the ship the way chopsticks squeeze food. Public photos and industry reporting show small catch points sticking out near the top of the ship. The arms close in under those points, and the ship settles onto them, held from just under its shoulders.

Simplified diagram of the Mechazilla tower arms closed under the catch points near the top of the Starship ship
The arms close under catch points near the top of the ship. Simplified diagram; catch point location from public photos and reporting.

The same arms move up and down the tower and swing open and shut. Before a flight, that machinery lifts each rocket onto the launch mount. In September, crews used the arms to lift this exact ship into catch position as a rehearsal. It was also a first for that tower. Starbase has two towers, and this one, called Pad 2, had never caught anything before. Its first catch was a spaceship.

Why catch it at all

Legs are heavy, and every pound of leg is a pound of cargo a rocket cannot carry. Elon Musk made that case on X in December 2020: skip the legs, save the weight and cost, and let the tower set the rocket straight back on its launch mount.

On its Starship page, SpaceX says Starship is designed to be caught and launched again without being rebuilt, the way an airliner lands, refuels and flies. SpaceX argues that is how launches get cheaper, and it is already offering cargo flights to the Moon starting no earlier than 2028.

What still has to go right

It is not there yet. No caught Starship has flown a second time, and nobody outside SpaceX knows how much work this ship needs before it could. The booster on the same flight is the reminder: one burn ended early, and a rocket that was meant to come home was lost at sea.

The next big test is flying a caught ship again. When that happens, we will break it down the same way.

Share

WhatsApp X LinkedIn Email

Insights by TechCity, every Sunday.

Tech explained for people who use it.

Olawale Adeyina Avatar